Here is a picture with the new parts installed and the side cover off
The unit is heavy and awkward and sits in under the table and is not easy to get out
But is the place I have room for it

here is the side pannel removed and with holes for the fuse holders
that I can check without removing the unit

The black spot from the marker is where I would like to mount a led
I would like to mount one for each fuse

I had planed on doing this in the beginning but did not get arround to it
and now I can not finde my information on my computer
or somthing on cnczone where I think I got it anyway

The other part I am holding is a unit that is made by the manufacture of my power supply
here is a better view
click here to see

I believe i can use the same resistors he uses in the part and solder one to my led and glue it in the hole?
so here is where I need help I cant remember how to wire it

I believe one end of the resistor goes to the positive wire then the Led
then mabey connects to the other side of the fuse? I think it connects to the fuse somehow cant remember

and also I have some green Leds with 5v resistor built in left over from somthing can I use them?

these connect to a grex for now and gecko 320 drives
if any info is needed just let me know I would like to do it right this time